Vinyl Fence Post Installation Guide

In this story we ll cover the installation of a board and rail fence.

Vinyl fence post installation guide.

Install the vinyl fence sections between each post. When staking out line posts on a slope for a step method installation you ll need a true horizontal measurement for post placement. There are a few precautions before unloading and installing any vinyl fence. Generally vinyl fence sections snap right into place.

Installing a vinyl fence on a slope requires the use of the step method. Run a string over the top of posts from end to end of each fence line. This flexibility depends on proper vinyl fence installation. Snap the ends of the top and bottom rails into the appropriate holes on the fence posts.

Protect all components during transport. Assemble them according to manufacturer s instructions. Always place vinyl fence components on a non abrasive surface such as a drop cloth to avoid scratches. Then set the rest of the posts to height by lifting to the string and fastening to collars either through u channel and post into top collar or bottom.

When assembling the components avoid excessive force particularly overtightening screws. Vinyl fencing will bend without breaking allowing it to withstand high winds and minor impacts. Installing a vinyl fence. Don t install posts too close together.

Set the corner and end posts first. This page is our vinyl fence planning guide to help you better understand how to plan your fence project and to help ensure that no details get overlooked. We have put together a list of vinyl fence plans plus visual guides which will help you determine what s needed to complete your project and to provide ideas and options for unique situations. The fence gradually steps up the slope so that each bay section is the same length and the rails are level instead of parallel to the slope.

Follow the specific manufacturer s directions regarding vinyl fence sections as some may slide halfway into the post. Set end posts and corner posts for height by inserting a screw or two into the lower collar through the vinyl post.