Using The Smartthings Multipurpose Sensor For Garage Door

But the reason i wanted to use the multipurpose sensor is because we.

Using the smartthings multipurpose sensor for garage door.

As you can see i ll have to attach one piece on moulding that isn t even and obviously a piece on the door. Need some suggestions on good placement for this st multipurpose sensor on my door. I added the multipurpose sensor but there was no option to change this to garage door mode. How to set up the smartthings multipurpose sensor as a garage door open closed.

I have a smartthings multipurpose sensor on my garage door and an lfm 20 z wave switch attached to the door opener. I am using the new smartthings app and have a simple open close sensor on my garage door. Overall there are loads of smartthings garage door sensor options available. This is our latest generation of multipurpose sensor.

Can anyone please help. Today i can say alexa turn on the garage door opener and it will momentary press and the door will move to the opposite of the position it s in open closed. So i logged into the website and updated the type to smartsense garage door multi. Just using the samsung multi purpose sensor.

At 20 as of the time of writing the tiny samsung smartthings multipurpose sensor zigbee does a lot for very little. Also i noticed that this sensor is always reporting incorrect temperature right now it is showing 808. I ve tried to do the same thing in the new app too. The are 17 today on amazon.

Depending on your needs you may select a tilt sensor contact sensor or even a multi purpose sensor. Any advice on which piece would be better suited to which side. It asks is this a garage door. I set it up with the options do you want to use this sensor on a garage door set on and three axis reporting options set to disabled.

When it goes up it sets open and when it goes down it changes to closed. If you have a first generation sensor contact support for. The following instructions apply only to the smartthings multipurpose sensor. I put a smartthings multipurpose sensor on the top of the garage door with the straight line to the right.

It works in harmony with the tilt sensor on the gocontrol garage door opener. Is it possible to create a notification if my garage door has been left open for 30 minutes. Have it stuck to the top of the garage door. For basic sensing a tilt sensor is more than enough.

You say yes and it does the rest for the device type. Garage door sensor for smartthings. Howdy i am using the new smartthings app. To my knowledge the new app doesn t have that capability yet without adding your own smartapp.

After that it is always showing open. Using classic smartthings app.